Articles

Instrumentation Amplifier vs Op Amp: Key Differences

Electronics Instrumentation Amplifier vs Op Amp: Key Differences A single op amp can be wired as a difference amplifier in minutes, yet plenty of sensor.

Learn More

Ferrite Bead vs Common Mode Choke: When to Use Which

Electronics Ferrite Bead vs Common Mode Choke: When to Use Which Both parts look similar on a bill of materials and both quiet down electrical.

Learn More

PFC Circuit Explained: 3 Boost Modes for Cleaner Input Power

Power Electronics & Protection PFC Circuit Explained: 3 Boost Modes for Cleaner Input Power A plain rectifier and capacitor sip current in sharp spikes, and.

Learn More

Thermal Vias: 6 Practical Rules for Cooler PCB Layouts

PCB Design & Signal Integrity Thermal Vias: 6 Practical Rules for Cooler PCB Layouts FR4 is a poor heat conductor, but a grid of small.

Learn More

Ground Bounce: 7 Proven PCB Fixes for Switching Noise

PCB Design & Signal Integrity Ground Bounce: 7 Proven PCB Fixes for Switching Noise When many outputs switch at once, the chip ground itself jumps,.

Learn More

Bode Plot Made Simple: 5 Easy Steps to Check Stability

Electronics Fundamentals Bode Plot Made Simple: 5 Easy Steps to Check Stability Two simple graphs of gain and phase against frequency tell you whether an.

Learn More

Hall Effect Current Sensor: 4 Smart Designs With Isolation

Electronic Sensors Hall Effect Current Sensor: 4 Smart Designs With Isolation Measure tens of amperes on a mains conductor while your microcontroller stays safely isolated,.

Learn More

Humidity Sensor Guide: 3 Types and 6 Accurate Install Tips

Electronic Sensors Humidity Sensor Guide: 3 Types and 6 Accurate Install Tips A thin polymer film soaks up water vapour and changes its capacitance, and.

Learn More

Precision Rectifier: 4 Smart Op Amp Designs for Tiny Signals

Analog Electronics Precision Rectifier: 4 Smart Op Amp Designs for Tiny Signals An ordinary diode ignores anything below about 0.6 V, but place it inside.

Learn More

Current Mirror Circuit: 5 Proven Designs for Precise Bias

Analog Electronics Current Mirror Circuit: 5 Proven Designs for Precise Bias Two matched transistors and one resistor can hold a steady current into almost any.

Learn More
Support free learning

Help keep every guide, calculator and tool 100% free

Hosting, software and hours of research go into every article. Even a small contribution helps us publish more in-depth guides for students, technicians and engineers.

  • No paywalls
  • No sign up
  • Free for everyone