Coriolis vs Magnetic Flow Meter
Side by side comparison: how they work, where each fits, and which to choose.
Quick answer: Coriolis measures mass flow and density of almost any fluid with top accuracy; a magmeter measures volume flow of conductive liquids with no pressure loss at lower cost, in very large sizes.
Coriolis vs Magnetic Flow Meter: Comparison Table
| Aspect | Coriolis | Magnetic Flow Meter |
|---|---|---|
| Measures | Mass flow, density, temperature | Volume flow |
| Fluids | Liquids, gases, slurries | Conductive liquids only |
| Typical accuracy | about ± 0.1 % of rate (liquid) | about ± 0.2 to 0.5 % of rate |
| Pressure loss | Moderate to high | Almost none (full bore) |
| Sizes | Mostly up to about DN 300 | Up to DN 2000 and more |
| Straight run | Usually none | about 5 D upstream, 2 D downstream (typical) |
| Cost | High | Moderate |
Choose Coriolis when
- Custody transfer, dosing and batching by mass
- Non conductive liquids, oils, gases
- When density is also needed
Choose Magnetic Flow Meter when
- Water, wastewater and slurries
- Large pipes and low pressure systems
- Cost sensitive volume measurement
Key Differences Explained
A coriolis meter vibrates its tubes and senses the twist caused by mass flow. A magmeter uses Faraday law: conductive liquid moving through a magnetic field creates a voltage proportional to velocity.
For water in large pipes the magmeter almost always wins; for hydrocarbons, chemicals and anything needing mass, the coriolis meter does.
Related Glossary Terms
Free Calculators
Frequently Asked Questions
What is the difference between Coriolis and Magnetic Flow Meter?
Coriolis measures mass flow and density of almost any fluid with top accuracy; a magmeter measures volume flow of conductive liquids with no pressure loss at lower cost, in very large sizes.
Can a magmeter measure oil?
No. Oil is not conductive enough.
Does coriolis need zeroing?
Yes, a zero at process conditions with the line full and still improves low flow accuracy.
Which has less maintenance?
Both have no moving parts; magmeter liners and electrodes and coriolis tubes can wear in abrasive service.
Learn more on the blog
Coriolis flow meter uncertainty
A practical guide on instrumentationblog.in that goes deeper into this topic with field examples.
Read Full ArticleMore Comparisons
All comparisons · Instrumentation glossary