Linear vs Equal Percentage
Side by side comparison: how they work, where each fits, and which to choose.
Quick answer: Use linear where the valve takes most of the system pressure drop; use equal percentage where the valve drop falls as flow rises, which is most process loops.
Linear vs Equal Percentage: Comparison Table
| Aspect | Linear | Equal Percentage |
|---|---|---|
| Inherent curve | Cv proportional to travel | Equal % change of Cv per travel |
| Best when | Valve ΔP nearly constant | Valve ΔP falls with flow |
| Typical loops | Level, some pressure loops | Flow, temperature, most pressure loops |
| At low authority | Behaves like quick opening | Becomes near linear installed |
Choose Linear when
- High valve authority systems
Choose Equal Percentage when
- Pumped systems with large pipe and equipment losses
Key Differences Explained
What matters is the installed characteristic: flow against travel in the real system. Aim for a nearly linear installed curve so loop gain stays steady.
When in doubt, equal percentage is the safer default for process control.
Related Glossary Terms
Free Calculators
Free Downloads
Frequently Asked Questions
What is the difference between Linear and Equal Percentage?
Use linear where the valve takes most of the system pressure drop; use equal percentage where the valve drop falls as flow rises, which is most process loops.
Can the positioner change the characteristic?
Yes, with a characterising curve, but resolution at low travel still comes from the trim.
What is quick opening for?
On off and relief duty.
How do I check?
Calculate flow at several openings with the system curve.
Learn more on the blog
Control valve flow coefficient (Cv and Kv)
A practical guide on instrumentationblog.in that goes deeper into this topic with field examples.
Read Full ArticleMore Comparisons
All comparisons · Instrumentation glossary